Thermon ZE-B Beacon Terminator Bedienungsanleitung PDF herunterladen (Seite 3)

1. Locate bus connection (HPT and FP only) and

cable as shown. Cut end of cable at angle to

aid in piercing grommet. Leave additional cable

for expansion loop.

3. Slide expediter toward pipe and route cable

through support base entry.

4. Insert banding guide into expediter and snap

into place.

5. Mount expediter to pipe using pipe band. Do

not band over cable.

2. Insert cable into expediter. If mounted on

bottom of pipe, punch out weep hole.

6. Cut off end of cable.

7. Terminate cable with appropriate SCTK

termination kit. Refer to SCTK installation

instructions. Push excess cable back through

expediter. Remove braid pigtail. Tape cable

expansion loop to pipe.

50mm

(2")

Max.

300mm

(12")

Bus

Connection

Weep Hole

101mm

(4") Min.

Do Not Band

Over Cable

25mm

(1") Min.

Expediter

Assembly

Boot

Wire Crimp

Heating Cable

Light Module

Light Module

Wiring

Wiring Details for LED Light

LED Light PigtailHeating Cable

8. Connect heating cable to light module wires

using small crimps. Discard large crimp. See

wiring details.

Expediter

Terminator

TM

ZE-B Beacon INSTALLATION PROCEDURES

1 2 3 4

Terminator 1
ZE-B Beacon 1

Kommentare zu diesen Handbüchern

Keine Kommentare